In the Delete mode, press the C key to delete the character highlighted by the cursor. Pressing and holding
the C key will repeat this operation.
To Copy and Paste the Text
To copy and paste text, proceed as described below:
To
1
Activate the copy function
2
Specify the copy starting point
3
Specify the copy ending point
4
Specify the paste point
5
Paste the block
To Cut and Paste the Text
To cut and paste text, proceed as described below:
To
1
Specify the cut function
Do this
Press the Options menu key in the text input mode, then
select Copy.
Move the cursor to the starting point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : You can cancel the specified copy starting point by
pressing the C key.
Move the cursor to the ending point of the block to copy by
using the Up, Down, Left, or Right key and press the Enter
key.
Note : Maximum capacity of clip board is 1024 byte.
Move the cursor to the paste point by using the Up, Down,
Left, or Right key.
Press the Options menu key in the text input mode, then
select Paste.
Repeat the steps one to four if necessary.
Note : If the copied text exceeds the maximum number of
characters allowed in the field, the message asking
whether you want to discard the remaining characters or
cancel the paste operation.
Do this
Press the Options menu key in the text input mode, then
select Cut.
-35-
Text Entry