To Edit An Alarm - NEC e616 User Manual

To
7 Set clock alarm vibration and snooze
8 Fix the settings in the alarm entry
9 Enable the set alarm
Useful Tips
• When the alarm goes off and vibration occur, press the SK1 (Turn off) key to stop the alarm.
• When the alarm goes off and you have set snooze, do any of the following:
- To stop the alarm clock and cancel the snooze function, press the SK2 (Off) key.
- To snooze, press the SK1 (Snooze) key. After five minutes, the alarm clock operation will go off again.
- To not stop the alarm going off, press no keys. After three minutes, the snooze screen is displayed. To
stop the alarm at this point, press the SK2 (Cancel) key. If you do not press any more keys, the alarm
clock will go off again after five minutes.
The alarm clock goes off up to three times in all, unless you stop the snooze function or stop the alarm
clock.

To Edit an Alarm

You can cancel an alarm clock setting, change setting time, etc. To edit your alarm clock setting, press the
SK1 (Edit) key and edit. Proceed as described in To Set an Alarm other than the following:
To
1 Set alarm clock status
Do this
Place/remove a check in Vibration and in Snooze.
When the snooze is set on, once the alarm goes off, sound and
vibration occurs at five minutes intervals up to three times,
unless you stop the snooze function or stop the alarm clock.
Press the SK1(OK) key in the alarm setting screen.
Make sure that the set alarm is set to on. When the alarm is
disabled or off, set it to on. Refer to To Edit an Alarm on page
157.
Do this
To change the alarm clock status from On to Disable, press
the SK2 (Disable).
To change the alarm clock status from On to Off, press the
SK2 twice (SK2 (Disable) -> SK2 (Off))
Disable cancels the next alarm but does not cancel recurring
alarm.
Off: indicates the set alarm clock is turned off but remains.
-157-
Toolbox