To perform local USB synchronisation
Connect the e616 and a PC with the supplied USB cable and follow the steps below:
When using the USB cable for the first time, ensure the USB Drivers are installed. See the Software
Manual on the CD-ROM for further instructions.
Usually only the updated data will be synchronised, however all data is synchronised during the very first
sychronisation or when there was an error during the last synchronisation.
To
1
Connect e616 and PC
2
Set IntelliSync application to use USB Run the Intellisync software, click
3
Confirm connection
4
Start synchronisation
Connections
Do this
Connect the handset and PC with the supplied USB cable.
Phone Options
Connections tab
Note : This operation has to be performed only once.
Once the USB cable has been connected and USB connection
selected, the red line across the 'IntelliSync' logo on the
Windows Taskbar tray will disappear.
Note : If the red line across the logo remains, the PC has not
detected the e616 and synchronisation will not take
place.
On your e616, press the MENU key
Synchronisation
Select the USB server to synchronise, press the SK1 (Start).
The IntelliSync software on the PC will run automatically.
The updated data on the handset and the PC will be
sychronised, depending on the options selected in the
'IntelliSync' Software.
-128-
Configure
NEC e616
select USB
External connection