Battery; Charging - NEC e606 Product Manual

Battery

To Insert the Battery
Place the bottom of the battery into position and then push down on the upper section of the battery until it
clicks into place.
To Remove the Battery
1 Ensure that your handset is switched off. If the handset is switched on, press and hold the End (On-
Off) key until power is off.
2 Push up the release catch at the top of the battery and lift the battery away from the handset.
The battery is not fully charged when you buy your handset but there may be enough power in the battery to
turn the handset on. A battery that has not been used for a long period of time needs to be completely
discharged and then recharged two or three times before reaching full capacity. Charge the battery by
following the procedure indicated below.
The battery can also be charged whenever you wish without affecting the performance of the handset.
The e606 automatically switches off if the battery voltage is too low.
Batteries have a life cycle. If the time that the battery powers equipment becomes much shorter than
usual, the battery life is coming to an end. Replace the battery with a new one of the same type.
When not using the battery for a long period, remove it from the e606 and store in a place with low
humidity and low temperature.

Charging

Charge the battery by using the charger supplied with your handset. When the battery is fully charged, a full
battery power level icon will be displayed. Refer to Low Battery Alarm on the next page for details.
To Charge the Battery Using the Charger
1 Make sure that the battery is attached to your handset.
2 Connect the charger plug to the e606 I/O connector. See the diagram on the next page.
3 Plug the charger into a power socket. The red LED indicator on the outside of your e606 will light up
when charging is in progress and go off when charging is completed.
4 After charging the battery, tilt the charger plug upward and pull it away from the e606 I/O connector.
-6-
Setup