Changes In This Manual - Siemens SINAMICS G120D Operating Instructions Manual

Changes in this manual

Notable changes since the 04/2015 edition of the manual
New functions in firmware V4.7 SP6
● Evaluation of a PT1000 motor temperature sensor
● New p4621 parameter for disabling PTC short-circuit monitoring
● Revision of the thermal motor models: p0612 bit 08, 09 and 12
● Support for 1PC1 induction motors
You can find an overview of all new and modified functions in firmware V4.7 SP6:
Corrections
● The "Moment of inertia estimator" function has been released for all permitted motors.
● It is not permissible that the output of the friction characteristic r3841 is interconnected
with p1511 or with p1513.
Converter with control units CU240D-2
Operating Instructions, 07/2016, FW V4.7 SP6, A5E34262100B AD
Motor temperature monitoring using a temperature sensor (Page 179)
Motor temperature monitoring using a temperature sensor (Page 179)
Protecting the motor by calculating the motor temperature (Page 183)
Motor series that are supported (Page 29)
New and extended functions (Page 321)
Moment of inertia estimator (Page 168)
Friction characteristic (Page 166)
5