■ C-4.4
DISCONNECTING THE BATTERY
During maintenance or repair works, and while welding,
turn off the battery main switch
front right wheel compartment.
Handler with telescopic boom GTH-2306
OPERATING INSTRUCTIONS
, located behind the
C-23
Page
Document 57.0002.2200 - 12/2002
■ C-4.5
STARTING THE MACHINE
When the engine reaches the running temperature,
ensure all parts are in transfer position and the gearbox
lever is in neutral. Then, proceed as follows:
•
Select a gear suiting the job you are going to carry
out and the conditions of the job site.
•
Select the required steering mode.
•
Select the required gear (forward or reverse).
•
Release the parking brake.
•
Slowly step on the gas pedal to start moving off.
CAUTION
Do not operate the forward/reverse gear lever when
the machine is running. The machine would reverse
the running direction abruptly and you could
seriously be injured.