Figure 115. Optical drive retainer installation
Step 5.
Hold the optical drive or tape drive in the correct orientation; then, slide it into the drive bay until it
snaps into position.
Figure 116. Optical drive installation
Step 6.
Connect the power cable and the signal cable to the rear of the optical drive or tape drive. See
"Optical drive cable routing" on page 52 or "Tape drive cable routing" on page 54.
After you finish
1. Reinstall the front bezel. See "Install the front bezel" on page 106.
2. Reinstall the front door. See "Install the front door" on page 109.
3. Reinstall the server cover. See "Install the server cover" on page 190.
4. Complete the parts replacement. See "Complete the parts replacement" on page 206.
Remove the 5.25-inch drive bay adapter assembly
Use this information to remove the 5.25-inch drive bay adapter assembly.
About this task
S002
.
Chapter 4
Hardware replacement procedures
153