Inspections & Adjustments - Grizzly G0561 Owner's Manual

4. Raise bow about halfway, then close feed
ON/OFF valve to lock bow in place (see
Figure 28).
Feed ON/OFF
Valve
Figure 28. Location of feed ON/OFF valve.
5. Connect machine to power supply.
6. Use motor ON/OFF switch (see Figure 29) to
turn machine ON and verify motor operation.
The motor should run smoothly and without
unusual problems or noises.
7. Use pump ON/OFF switch (see Figure 29) to
turn coolant pump ON. Coolant should flow
through blade guide and onto blade.
Figure 29. Location motor and pump ON/OFF
switches.
8. Turn OFF pump.
-22-
Motor
ON/OFF Switch
Pump
ON/OFF Switch
9. Open feed ON/OFF valve to fully lower head-
stock. When headstock is in lowest position,
automatic shut-off tab should switch power
OFF.
— If shut-off tab does switch power OFF, tab
is functioning correctly. Congratulations!
Test Run is complete.
— If shut-off tab does not switch power OFF,
tab is not working correctly. This safety
feature must work properly before pro-
ceeding with regular operations. Call Tech
Support for help.
Inspections &
Adjustments
The following list of adjustments were performed
at the factory before the machine was shipped:
Blade Tension & Tracking ...............Page 45
•
• Squaring the Blade ..........................Page 46
• Blade Guide Bearings .....................Page 46
Be aware that these can change during the
shipping process. Pay careful attention to these
adjustments when first operating the machine. If
you find that the adjustments are not set to your
personal preferences, re-adjust them.
Model G0561 (Mfd. Since 01/18)