Multitech MT1932ZDX Quick Reference Manual page 44

MT1932ZDX Quick Reference Guide
Command: &W n
Values:
Default:
Description: &W0
&W1
X n
Command:
Values:
Default:
Description: X0
X1
X2
X3
X4
Command: #X n
Values:
Default:
Description: #X0
#X1
44
Store Configuration
n = 0 or 1
1
Store current settings in NVRAM; load them at
power-on or following the ATZ command instead
of loading the factory defaults from ROM.
Clear user default settings from NVRAM.
Result Codes and Call Progress Selection
n = 0–4
0
Basic result codes ( CONNECT only); does not
look for dial tone or busy signal.
Extended result codes ( CONNECT 28800,
CONNECT 33600 , etc.); does not look for dial
tone or busy signal.
Extended result codes with NO DIALTONE ; does
not look for busy signal.
Extended result codes with BUSY ; does not look
for dial tone.
Extended result codes with NO DIALTONE and
BUSY .
Number of XOFF Characters Sent
n = 0 or 1
0
Single XOFF character sent after buffer is full.
Multiple XOFF characters sent (one for every
character received after buffer is full).