Multitech MT1932ZDX Quick Reference Manual page 32

MT1932ZDX Quick Reference Guide
Command: D s N d Store Telephone Number
Values:
Default:
Description:
Command: &D n
Values:
Default:
Description: &D0
&D1
&D2
&D3
Command: $D n
Values:
Default:
Description: $D0
$D1
%DC n AT Command Control
Command:
Values:
Default:
Description: %DC0 Command Mode enabled (AT commands).
%DC1 Command Mode disabled (ignores AT commands
Note: The modem will respond to AT%DC for 10 seconds after power-up.
32
s = dial string (phone number and dial modifiers)
d = 0 or 1
none
To store, enter D followed by dial string s , then N
followed by directory number d .
Example: ATDT9,5551212N1.
Data Terminal Ready Control
n = 0–3
2 (ZDX, ZDXI, ZDXK)
0 (ZDX-Mac, ZDXK-Mac)
Modem ignores DTR signal.
When DTR drops, the modem hangs up. While
DTR is low, the modem accepts commands but
will not dial or auto-answer until DTR goes high
again.
Same as &D1.
When DTR drops, the modem hangs up and
resets as if an ATZ command were issued.
DTR Dialing
n = 0 or 1
0
Do not dial when DTR goes high.
Dial stored number N0 when DTR goes high.
n = 0 or 1
0
after 10 seconds)