Signal Connections; Front Connector - National Instruments SCXI-1320 User Manual

For installation procedures with other SCXI accessories and data acquisition boards,
Note
consult Appendix E,

Signal Connections

Refer to the Read Me First: Safety and Electromagnetic Compatibility document
Caution
before removing equipment covers or connecting/disconnecting any signal wires.

Front Connector

© National Instruments Corporation
5. If this module is to be connected to an MIO-16 data acquisition board,
attach the connector at the metal end of the SCXI-1340 cable assembly
to the rear signal connector on the SCXI-1121 module. Screw the rear
panel to the rear threaded strip. Attach the loose end of the cable to the
MIO-16 board.
SCXI-1121 Cabling.
6. Check the installation.
7. Turn on the SCXI chassis.
8. Turn on the computer or reconnect it to your chassis.
The SCXI-1121 module is installed and ready for operation.
This section describes the input and output signal connections to the
SCXI-1121 board via the SCXI-1121 front connector and rear signal
connector, and includes specifications and connection instructions for the
signals given on the SCXI-1121 connectors.
Use only National Instruments TBX Series cable assemblies with
high-voltage TBX Series terminal blocks.
Figure 2-3 shows the pin assignments for the SCXI-1121 front connector.
Chapter 2
2-15
Configuration and Installation
SCXI-1121 User Manual