Advertisement
BRAKE FLUID
Inspect the brake system routinely.
Inspect the brake fluid level before each
operation. If the level drops between
fluid checks, add brake fluid as needed.
Your authorized dealer can provide
service.
1. Position the vehicle on a level surface.
2. Open the hood. The brake fluid reservoir is located on the driver's side of the
vehicle, above and to the rear of the front tire.
3. View the brake fluid level in the reservoir. The level should be between the
upper (MAX)
4. If the fluid level is lower than the upper level line, add brake fluid to the upper
(MAX) line.
5. Apply the brake forcefully for the few seconds and check for fluid leakage
around the fittings.
Change the brake fluid every two years and any time the fluid becomes
contaminated, the fluid level is below the minimum, or if the type and brand of
the fluid in the reservoir are unknown. Always use DOT4 brake fluid.
After opening a bottle of brake fluid, always discard any unused portion. Never
store or use a partial bottle. Brake fluid is hygroscopic, meaning it rapidly
absorbs moisture from the air. The moisture causes the boiling temperature of
the brake fluid to drop, which can lead to early brake fade and the possibility of
Brake fluid may cause damage to painted and finished surfaces. Use caution
q
and lower (MIN)
accident or severe injury.
when refilling the brake fluid reservoir.
w
level lines.
WARNING
NOTICE
MAINTENANCE
65
Advertisement
