Advertisement
SEAT ADJUSTMENT
Seats can be adjusted forward or rearward. The seat adjustment lever is directly
under the front of the seat.
1. Move the adjustment lever to the left and slide the seat to the desired
position.
2. Release the lever.
3. Make sure the seat latches securely in position. Test the latch by attempting
to slide the seat forward and rearward while seated.
SEAT BELTS
Riding in this vehicle without wearing the seat belt increases the risk of serious
injury in the event of an accident or sudden stop. Occupants must wear seat
belts at all times. Always make sure the seat belts are secured for operator and
all passengers before operating. See page 51.
PROPER SEAT BELT USE
This vehicle is equipped with three-
point lap and diagonal seat belts for
all occupants. Always make sure the
seat belts are secured for operator
and all passengers before
operating.
When the key is turned on, the seat
belt indicator lamp will illuminate if
the driver's seat belt is not fastened.
To wear the seat belt properly, follow
this procedure:
1. Pull the seat belt latch
at the inner edge of the seat.
2. Slide the buckle
across your hips. The belt should fit snugly across your hips and diagonally
across your chest. Make sure the belt is not twisted.
3. Push the latch plate into the buckle until it clicks.
4. Release the strap, it will self-tighten.
5. To remove slack in the lap belt portion of the belt, pull upward on the
shoulder belt. To loosen the lap belt if it is too tight, tilt the buckle and pull the
lap belt slightly longer.
6. To release the seat belt, press the square red button in the buckle's center. If
necessary, slide the buckle down the webbing to allow it to retract fully.
q
downward and across your chest toward the buckle
w
up the webbing as far as needed for the belt to reach
FEATURES AND CONTROLS
51
Advertisement
