Advertisement
INFORMATION DISPLAY MODE
This area will display clock, odometer, trip meter, state of charge (SOC), range
meter, efficiency rate (EFF) or any existing fault codes or warning messages.
The display can be changed to show either standard or metric units of
measurement for each of the following settings.
Distance
Temperature
Time
1. Turn the key to the OFF position.
2. Press and hold the MODE button while turning the key to the ON position.
3. When the display flashes the distance setting, tap the MODE button to
advance to the desired setting.
4. Press and hold the MODE button to save the setting and advance to the next
display option.
5. Repeat the procedure to change remaining display settings.
To exit the set-up mode, turn the key off. Wait 5 seconds, then turn the key on.
The gauge displays the mode that was displayed prior to setting the units.
CLOCK RESETTING
The clock must be reset any time the batteries have been disconnected or fully
1. Turn the key to the ON position. Use the MODE button to toggle to the clock
display.
2. Press and hold the MODE button until the hour segment flashes. Release
the button.
3. With the segment flashing, tap the MODE button to advance to the desired
setting.
4. Press and hold the MODE button until the next segment flashes. Release the
button.
FEATURES AND CONTROLS
Standard Display
Miles
Fahrenheit
12-Hour Clock
TIP
TIP
discharged.
Metric Display
Kilometers
Celsius
24-Hour Clock
33
Advertisement
