Table of Contents
Advertisement
Intel® Server System M50FCP1UR System Integration and Service Guide
1. Ensure that the drive extraction lever is in the open position, and the drive rail is pulled out as far as
possible.
2. Align and insert the drive into the drive bay. See Letter A.
Note: Intel recommends holding the drive with one hand while holding the lever with the other hand.
3. Slide the drive into the drive bay until it is fully seated within the drive interface connector on the
backplane (see Letter B).
4. Close the drive extraction lever until it locks into place. See Letter C.
3.5
Ethernet Network Adapter for OCP* Installation
This section provides instructions for the installation of an OCP* add-in card. OCP add-in cards will have one
of two possible methods to secure the card within the OCP bay. Refer to the sub-section that supports the
card to be installed.
Pull-Tab and Thumb Screw – Section 3.5.1
•
•
Internal Lock – Section 3.5.2
Required Tools and Supplies
•
Anti-static wrist strap and conductive workbench pad (recommended)
Phillips* head screwdriver #1
•
Note: Reference the Intel® Server M50FCP Family Configuration Guide for a list of supported adapter cards.
Figure 42. 2.5" Drive Installation into Front Drive Bay
41
Advertisement
Table of Contents
