Jeep CHEROKEE 2023 Owner's Manual page 240

238 SERVICING AND MAINTENANCE
Tire Terminology And Definitions
Term
B-pillar
Cold Tire Inflation Pressure
Maximum Inflation Pressure
Recommended Cold Tire Inflation Pressure
Tire Placard
Tire Loading And Tire Pressure
NOTE:
The proper cold tire inflation pressure is listed on the
driver's side B-pillar or the rear edge of the driver's side
door.
Check the inflation pressure of each tire, including the
spare tire (if equipped), at least monthly and inflate to the
recommended pressure for your vehicle.
The vehicle B-pillar is the structural member of the body located behind the front door.
Cold tire inflation pressure is defined as the tire pressure after the vehicle has not been driven for at least
three hours, or driven less than 1 mile (1.6 km) after sitting for a minimum of three hours. Inflation
pressure is measured in units of psi (pounds per square inch) or kPa (kilopascals).
The maximum inflation pressure is the maximum permissible cold tire inflation pressure for this tire. The
maximum inflation pressure is molded into the sidewall.
Vehicle manufacturer's recommended cold tire inflation pressure as shown on the tire placard.
A label permanently attached to the vehicle describing the vehicle's loading capacity, the original
equipment tire sizes and the recommended cold tire inflation pressures.
Example Tire Placard Location (Door)
Definition
Example Tire Placard Location (B-pillar)