Pad Replacement; Brake System Maintenance - Huffy KD58C-LCD Owner's Manual

Adjusting Barrel
or IN to loosen the brakes.
NOTE: Make sure the Adjusting Barrel threads are fully engaged. Check adjustment again.
8. If you cannot reduce the gap by turning the Adjusting Barrel, the brake pads might be
worn out and need to be replaced.

PAD REPLACEMENT:

1. Remove the Caliper Mounting Bolts
2. Remove the Caliper assembly
3. Remove the Brake Pads from the Caliper.
4. Install the new Pads using same type and size.
5. Install the Caliper assembly
shown).
6. Tighten the caliper Mounting Bolts
7. Route the Cable
• Ensure Cable Housing
8. Pull the Cable through the Cable Clamp, and tighten the Clamp
NOTE: Brake adjustment involves loosening the Cable Clamp Bolt. During installation, it only
needs to be tightened enough to make sure the Cable End doesn't pull back through the
Camp.
9. Adjust the Brake (as described above).

BRAKE SYSTEM MAINTENANCE:

• Check brake operation and adjustment before each ride.
• Keep the brake system free of dirt, mud, oil, and other foreign substances that will inhibit
proper operation.
• Frequently check:
• All components for damage.
• The pads - for wear.
• The lever - for smooth operation.
• The cable - ensure there are no frayed ends, cuts, or kinks that inhibit operation. Add
cable lube if the cable is dry.
• All bolts and fasteners - ensure the bolts are tightened, replace any that are damaged.
NOTE: These are general instructions. Please refer to component
manufacturer's documentation for product specifi c instructions.
Disc Brake System - continued
C
on the Caliper. Turn the Adjusting Barrel OUT to tighten the brakes
E .
E
to the mounts on the fork (front), or frame (rear) (front
F
D
through the lower Adjusting Barrel
G
is fully inside Adjusting Barrel
F .
securely.
C
and Cable Clamp
C
.
A
Bolt.
A
.
25