Printer Unit-Removing And Replacing - IBM NetVista Kiosk DBCS Hardware Service Manual

Printer unit–removing and replacing
Follow these steps to remove or replace the printer unit.
Attention:
information, see the section on "Electrostatic discharge (ESD)" on page 158 of the
Hardware Service Manual.
Establish personal grounding before touching this device. For more
1. Before removing the printer, backup the customer's printer parameters to a
diskette using the Backup/Restore Printer Parameters option located on the
Utilities menu on the Service Diskette. See "System diagnostics and
troubleshooting" in Hardware Service Manual.
2. Power off the NetVista Kiosk. See "Powering off the NetVista Kiosk" on page 4.
Make sure that the 4835, printer scanner, power distribution switch, and the
UPS are powered off.
3. Unplug the power cord from the customer's external ac power source going to
the Kiosk enclosure.
4. Unplug the printer power cord from the power strip.
5. Unplug the RS-232 cable A from the printer unit.
6. Unplug the 24V dc power-supply cable B from the power connector on the
printer.
A
B
The NetVista Kiosk-DBCS Model
21