Powering Off The Netvista Kiosk - IBM NetVista Kiosk DBCS Hardware Service Manual

Powering off the NetVista Kiosk

4
Use the following power-off sequence to ensure that the NetVista Kiosk components
are powered-off.
1. Switch off the power to the 4835 system by pressing the power button with a
paper clip. The power button is located on the front bottom of the 4835 display.
The display indication lights A will not be lit.
2. Unplug the power cord B that runs from the NetVista Kiosk enclosure to the
external ac power source.
3. Unlock the enclosure and slide the front of the enclosure forward. See "Opening
the enclosure" on page 9 of the Hardware Service Manual.
4. Turn off the power switch C on the optional UPS (if installed).
5. Switch off the power-distribution strip D .
6. Make sure that the scanner is powered off by holding a white sheet of paper at
location E . No red light pattern will be displayed.
A
E
C
D
B