Error Codes - Fluke 5560A Operator's Manual

Error Codes

The subsequent is a list of the Calibrator error messages.
Error 0 result No error
Error -440 result 488.2 query after indefinite response
Error -430 result 488.2 I/O deadlock
Error -420 result 488.2 unterminated command
Error -410 result 488.2 interrupted query
Error -376 result Command only allowed on synchronous (for example, gpib/usb-tmc) interface
type
Error -375 result Command only allowed on asynchronous (for example, serial/telnet) interface type
Error-374 result GPIB/488.1 unspecified error
Error -373 result GPIB/488.1 write operation timeout
Error -372 result GPIB/488.1 read/write operation aborted
Error -371 result GPIB/488.1 board address error
Error -370 result GPIB/488.1 system call has failed
Error -369 result LAN port encountered error while reading data
Error -368 result Fatal error occurred while accessing the LAN port
Error -367 result USB-TMC encountered error while reading data
Error -366 result GPIB/488.1 encountered error while reading data
Error -365 result Fatal error occurred while accessing the serial port
Error -363 result Input Buffer Overrun
Error -361 result RS-232 framing/parity/overrun error detected
Error -350 result Too many errors
Error -302 result Command execution locked out
Error -301 result Restricted Command
Error -224 result Characters must be A-Z, 0-9, - or _
Error -223 result Character string was more than limit
Error -222 result Illegal data value was entered
Error -193 result No entry in list to retrieve
Error -192 result Too many dimensions to be returned
Error -191 result Parameter type detection error
Error -190 result Parameter is not a boolean type
Error -157 result Unmatched bracket
Error -154 result String size is beyond limit
Error -153 result Parameter is not an unquoted string type
Error -152 result Parameter is not an quoted string type
Error -150 result Invalid string data
Error -140 result Parameter is not a character type
Error -138 result Too many suffixes in command header
Error -137 result Invalid suffix in command header
Error -130 result Suffix Error. Wrong units for parameter
Error -127 result Invalid dimensions in a channel list
Calibrator
Error Codes
67