Table of Contents
Advertisement
SINK TRAP/WASTE TEE INSTALLATION
1
2
3
4
18
PLUMBING & ELECTRICAL CONNECTION
Install the drain hose support to the
back wall, as close to the underside of
the countertop as possible. Refer to
'Plumbing & electrical considerations' for
minimum install heights.
Pull the hose through the drain hose
support before threading the hose
clamp onto the hose and fitting to
the sink trap. Secure to trap using the
clamp. Ensure hose is routed straight to
the trap.
Unplug or drill out the waste tee before
securing joiner to sink trap or waste tee.
Ensure the rubber washer is fitted when
connecting the inlet hose to the tap.
Hand-tighten into place.
Using a spanner or pliers, turn a further
180° to secure. Avoiding over-tightening.
Do not turn water supply on. The
dishwasher must be powered on for the
flood protection feature to be enabled.
Plug product in.
Non-hardwired installs only.
SINGLE AIR GAP INSTALLATION
1
2
3
4
Install your single Air Gap Kit to the
benchtop like shown.
Thread wire clip on to the hose before
fitting hose to the supplied hose joiner.
Secure using the hose clamps. Fit to
the Air Gap Kit. Ensure hose is routed
straight to the joiner, remove any excess
drain hose.
Unplug or drill out the waste tee before
securing to sink trap or waste tee.
Connect the inlet hose to tap and
handtighten into place. Using a spanner
or pliers, turn a further 180° to secure.
Avoiding over tightening.
Do not turn water supply on. The
dishwasher must be powered on for the
flood protection feature to be enabled.
Plug product in.
Non-hardwired installs only.
Advertisement
Table of Contents
