Table of Contents
Advertisement
INSTALL HARD PLUMBING
1
2
3
Fitting copper pipe:
Slide the compression nut and ferrule
towards the end of the pipe. Insert the
end of the pipe into the elbow and
screw the compression nut to the thread
of the elbow.
Braided hose installations:
Screw the nut of the hose to the thread
of the elbow. Hand-tighten then using
a spanner or pliers, turn a further 180°
to secure.
Connecting elbow to inlet valve:
Connect a 90° elbow to the water inlet
valve. Ensure a rubber gasket is placed
between the threads of the elbow and
water supply valve. The end of the elbow
must point to the rear of the dishwasher.
Do not over tighten the elbow.
Briefly turn on the water supply and
check for leaks, once you are satisfied
the connections will not leak turn off the
water supply.
SECURE DOOR PANEL
1
2
Align the door panel to the product. Slot
slider bracket and upper screws into
place. Slide the panel upwards to lock
into place.
Align door panel to surrounding
cabinetry. Open door and secure panel
to product using 4 x screws.
15
Advertisement
Table of Contents
