Connecting And Configuring The Analysis Probe - HP 16600A Series User Manual

Connecting and Configuring the Analysis Probe

This chapter shows you how to connect the logic analyzer to the target
system through the analysis probe.
If you are connecting to an HP 16600A-series or HP 16700A-series logic
analyzer, use the Setup Assistant to connect and configure your system
(see page 19). Use this manual for additional information, if desired.
If you are not using the Setup Assistant, follow the instructions given in
this chapter. This chapter covers the following tasks; the order shown
here is the recommended order for performing these tasks:
• Check that the target system meets the necessary requirements
• Read the power on/power off sequence
• Connect the analysis probe to the target system
• Connect the analysis probe to the logic analyzer
• Configure the logic analyzer
36 Solutions for CPU32