Replacing The Suction Filter - Xerox Versant 3100 Press User Manual

a) While grasping the handle with one hand, grip the top of the bottle with the
other hand.
The waste bottle may be heavy; therefore supporting the bottle with both hands
ensures that no dry ink / toner is spilled while removing the bottle.
b) Continue slowing pulling out the bottle from the press until it is completely
removed.
Caution
Never use a vacuum cleaner when cleaning up any spilled dry ink / toner. Use a
broom or a cloth moistened with a neutral detergent.
5. Place the full waste bottle into the plastic bag provided with the bottle.
6. Remove a new, empty waste bottle from the packaging.
7. Hold the center part on the top of a new bottle and insert it gently into the press until
it comes to a stop.
8. Close the center front door.
Note
After you replace the dry ink / toner waste bottle, the system automatically resets
the High Frequency Service Item (HFSI) usage counter for this CRU component to
zero (0). Check the consumables Supply screen to verify the reset.

Replacing the Suction Filter

Important
Before performing this procedure, ensure that you have the required T10 Torx driver
tool.
After replacing the filter, contact the system administrator. The administrator must log
into administrator mode and reset the High Frequency Service Item (HFSI) counter for
this CRU to zero (0).
Caution
Make sure the press is powered off before performing this procedure.
1. At the back of the press, locate the suction filter cover on the lower panel.
2. Us the Torx driver to remove the screw on the right side of the cover by turning the
screw counterclockwise (left).
® ®
Xerox Versant 3100 Press
User Guide
Maintenance
6-23