Subaru Crosstrek 2016 Owner's Manual page 131

2-30
Keys and doors/Alarm system
Transmitter
1) Arm button: Press to arm the system
2) Disarm button: Press to disarm the
system
Security indicator light (type A)
Security indicator light (type B)
6. Briefly press the button (for less
than 2 seconds). All doors (and the rear
gate on the 5-door) will lock, an electronic
chirp will sound once, the hazard warning
flashers will flash once, and the security
indicator light will start flashing rapidly.
After rapid flashing for 30 seconds (stand-
by time), the indicator lights will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
If any of the doors, (rear gate or trunk lid)
is not fully closed, an electronic chirp
sounds five times, the hazard warning
flashers flash five times to alert you that
the doors (or the rear gate) are not
properly closed. When you close the door,
the system will automatically arm and
doors will automatically lock.
To arm the system using power
door locking switches
1. Close all windows.
2. Remove the key from the ignition
switch (models without keyless access
with push-button start system )/turn the
push-button ignition switch to the OFF
position (models with keyless access with
push-button start system ).
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close the doors (and the rear gate on
the 5-door) but leave only the driver s door
or the front passenger s door open.
6. Press the front side ( LOCK side) of