Subaru Crosstrek 2016 Owner's Manual page 251

3-106
Instruments and controls/Mirrors
refer to your garage door opener s instruc-
tion manual.
1) Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the training light on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink
button that was programmed in the pre-
vious section. Press and release the
button a second time to complete the
programming procedure.
NOTE
Some garage door openers may re-
quire you to do the above press-hold-
release sequence a third time to com-
plete the programming.
4. The garage door opener should now
recognize the HomeLink
System and your garage door opener
should activate when the HomeLink
button is pressed.
Programming for entrance gates
and garage door openers in
Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLink
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
Wireless Control
®
®
1) HomeLink
2) HomeLink
3) HomeLink
2. Press and hold the two outer
HomeLink
3) until the HomeLink
buttons are
®
begins to flash (after approximately 20
seconds). Then release both buttons.
3. Hold the end of the entrance gate s/
garage door opener s hand-held transmit-
ter between 1 and 3 inches (25 and 76
mm) away from the HomeLink
wish to program.
4. Press and hold the desired HomeLink
button.
5. Press and release ( cycle ) the hand-
held transmitter button every 2 seconds
until step 6 is complete.
button 1
®
button 2
®
button 3
®
buttons (button 1 and button
®
indicator light
®
button you
®
®