EVGA Z790 CLASSIFIED User Manual page 31

EVGA Z790 CLASSIFIED (121-RL-E798)
2. Steps For Installing M.2 Devices
When installing the M.2 device, install the gold fingers at a slight angle into the slot, and
lower it so that it rests on the thermal pad.
For 80mm M.2 devices:

The screw/standoffs are included with
your MB accessories.

Remove the inner screw with a
screwdriver and fasten the standoff
portion to the 80mm interval on the
motherboard.

Remove the plastic cover on the thermal pad
from your intended M.2 slot.

Install the M.2 device and use the inner screw to secure
the device against the standoff.
For 42mm devices:

If you have a 42mm M.2 device, peel back the thermal pad cover and remove
sufficient length of the thermal pad to uncover the 42mm mounting hole.

Remove the inner screw with a screwdriver and fasten the standoff portion to
the motherboard to the 42mm interval.

Install the M.2 device and use the screw to secure the device.
Please carefully check your M.2 devices for proper installation before moving on to the
next step. If the M.2 device is not installed properly, the heatsink covers cannot be fully
fastened.
- 31 -