Outputting The Nmea Message On Usb; Outputting Nmea Data On Virtual Port Com2 - Magellan MobileMapper CX Getting Started Manual

Outputting the NMEA Message On USB

The USB port must be configured to emulate a serial port. Fol-
low the instructions in Setting the Mini-USB Port (I/O Module)
on page 5 to do this. Then:
, then Programs>GPS Utilities>GPS Ports Configura-
- Tap
tion.
- In the GPS Auxiliary Output pane, check on the Enable
Messages option and then select "COM6" in the Port field.
- Tap Configure Port to configure the selected port. Enter its
baud rate, number of start and stop bits and set its parity
and flow control parameters.
- Tap OK. MobileMapper CX will now deliver the NMEA mes-
sage you have defined on its USB port.

Outputting NMEA Data on Virtual Port COM2

From the moment a non-empty NMEA message is defined (see
page 64, MobileMapper CX will output this message on its vir-
tual port (COM2), independently of whether the message is
enabled on the auxiliary output port or not.
The COM2 settings can be displayed by tapping Port Status.
These settings cannot be changed:
• Baud rate: 57600 Bd
• Data bits: 8 data
• Parity: None
• Stop bit: 1
• Flow control: None.
65