Magellan MobileMapper CX Getting Started Manual page 79

4. Copy all the files extracted from the GPS firmware zip file
from your PC to the MobileMapper CX's SD card using
ActiveSync's Explore utility. The Explore button is located
in Microsoft Active Sync window's taskbar (third button
from the left).
5. Some versions of ActiveSync require that you click the
Explore utility's Folders button (in the task bar) in order to
copy/paste files from one location to another.
6. With the files copied to the SD card, tap the My Computer
icon on the desktop and select the SD card.
7. Double-tap baldur.exe (located on the SD card) to launch
the firmware loader.
8. On the firmware loader screen, tap the "Connect GPS" but-
ton and wait until the message "GPS connected at 4800"
is displayed in the firmware loader's white message field.
9. Tap the GPS firmware loader's "Load" button and wait
until the message "FLASH upload complete" is displayed
at the bottom of the screen.
10.Tap "X" on the top right corner of the GPS firmware loader
to close the application.
11.Tap "X" on the top right corner of Windows Explore.
12.Completely turn off MobileMapper CX by tapping:
>Shut Down and tapping OK.
13.Once MobileMapper CX's power light goes off, restart it,
>Settings>Control Panel and scroll down to the Magel-
tap
lan System Info icon.
14.Double-tap the Magellan System Info icon and confirm that
the GPS F/W version is that which you just uploaded.
15.To update another MobileMapper CX receiver with the lat-
est GPS firmware, remove the SD card and insert it into
the other receiver. Repeat Steps 6 through 14.
71