Sbas; Beacon - Magellan MobileMapper CX Getting Started Manual

SBAS

, then Programs>GPS Utilities>DGPS Configuration.
- Tap on
- Tap on the Select Mode button.
- In the Select Differential Mode window, enable the SBAS
option.
- Tap OK to close the window. This takes you back to the
DGPS Configuration window where you can read the
choice you have just made.
- Tap OK again. The window is closed and MobileMapper CX
starts operating instantly in SBAS DGPS mode, which
means it will dedicate two of its reception channels to
SBAS satellites, whenever visible and received, and only
the best one will be involved in the DGPS processing.
- Start your application.

Beacon

Two different connections to MobileMapper CX are possible
with MobileMapper Beacon: via Bluetooth (preferred) or using
a wire connection (RS232). For more information about Mo-
bileMapper Beacon, please refer to its Getting Started Guide.
1. If you are using Bluetooth:
- Place MobileMapper Beacon between 60 cm (two feet)
and 10 meters (about 30 feet) away from the MobileMap-
per CX. Do not stand squarely between the two. Bluetooth
requires line of sight, though you may place the Beacon
on your belt.
- Switch on both MobileMapper Beacon and MobileMapper
CX.
- On MobileMapper CX, tap on
Panel and double-tap Bluetooth Manager. The Bluetooth
window appears on the screen after a few seconds.
, then Settings>Control
31