Magellan MobileMapper CX Getting Started Manual page 46

38
- To enter your first NTRIP configuration, with New selected
in the NTRIP Configuration field, tap on the Add button and
then enter the following parameters:
• Name: NTRIP Configuration Name (freely choose a
name)
• Host: Host IP address
• Port: Port number
• Login: User name
• Password: User password
(The last four parameters should have been passed on
to you by the NTRIP provider.)
- Tap OK. The name of the configuration you have just cre-
ated is now pre-selected in the NTRIP Configuration field.
Two new buttons (Edit and Delete) are shown under this
field allowing you to respectively edit or delete this config-
uration. When you edit an existing configuration, note that
you cannot change its name.
To create a second NTRIP configuration, you would tap
the down arrow to the right of the NTRIP Configuration field
and select New. The Add button would appear again under
the field. You would then tap this button, enter the five
parameters of the second configuration and tap OK to save
this new configuration.
- After selecting the desired configuration from the NTRIP
Configuration field, tap OK. MobileMapper CX connects to
the NTRIP caster. The NTRIP Settings window is dis-
played again on which you can choose a network and sta-
tion (corrections source) from the caster. The Get Table
button is for downloading the new list of available stations
in the case you select a new provider from the Caster field.
- The best choice is to use the station the nearest to your
current location. Tap on the Find Nearest button to find and
select this station. This causes the Network and Station
fields to be automatically updated. The distance to this
station is indicated just underneath the Station field. A
second parameter in the same line tells you whether the
selected station provides VRS corrections data or not (VRS
for "Virtual Reference Station"; if VRS, the station pro-
vides corrections data for a virtual station that would be
located where you are. If not VRS, the corrections data are
computed for the true location of the station).