Nortel Meridian M3900 Reference Manual page 79

A red LED status light located on the ATA indicates the status of the ATA
as follows:
• Flashing red – indicates that the ATA is operating normally. For
more troubleshooting guidelines, refer to the user documentation
that came with your analog device.
• Solid red – indicates that the ATA is not operating normally.
• Red light off – indicates that there is no power going to the ATA or
the unit is not operating correctly. Check the power connections to
the ATA.
Flexible voice and data capabilities allow you to have continuous use of
both the Meridian Digital Telephone and the attached analog device.
Your system administrator configures the flexible voice and data
capabilities for your telephone on the system equipment. Contact your
system administrator for more information about flexible voice and data
capability.
When there is a power failure to the ATA, the Analog Device does not
store or keep information (for example, outgoing FAX from your FAX
machine). You must send the information again when power returns.
Table 17 shows prompts and responses when configuring the ATA.
Table 17
ATA configuration
Prompt
SO
LCC
Ringtype, group,
subgroup, NCOS,
SNPA, key, ringing
LEN_OR_LTID
OPTKEY
Meridian SL-100 M3900 Meridian Digital Telephones Reference Guide
Response
NEW
ATA
Follow normal
administration procedures
for an M3901 telephone
for these prompts.
A B C D
$
Installation 79
Description
Establish service for
unassigned telephone
lines.
Analog terminal adapter
line class code.
The prompts require
datafill specified by the
customer site.
A = IPE column.
B = IPE shelf.
C = IPE card slot.
D = IPE odd port.
There are no options
available for the ATA.