Wps Status Led - ADTRAN 834-v6 Quick Start Manual

Quick Setup for the 834-v6 SDG
Table 3 defines the multifunction status LED state when running PlumeOS.
Color LED State
Blue
Green
Green Blinking (double)
N/A
N/A
White Pulsing after 3 minutes
N/A
Green
Red Rapid Blinking
Back Panel Status LEDs
There are four LEDs located on the back panel of the 834-v6 as shown in
2.4GHz / 5GHz Status LEDs
The 2.4GHz and 5GHz status LEDs indicate the state of the wireless connections on the gateway.
LED Color
Green
2.4GHz / 5GHz
None

WPS Status LED

The WPS status LED indicates when WiFi Protected Setup (WPS)™ paring has been invoked.
LED Color
Blue
WPS
Tel 1/2 Status LED
The Tel 1/2 status LED indicate when when either of the voice lines are active.
LED Color
Green
Tel 1/2
None
Quick Setup for the 834-v6 SDG
The SDG product line can ship with two possible firmware options: PlumeOS and SmartOS. Quick setup instructions of WiFi and connection to
the Internet for your 834-v6 will vary based on which OS is installed on the device. Confirm whether your 834-v6 is deployed with SmartOS
firmware or PlumeOS firmware, then choose accordingly from the following options.
4
Table 3: Multifunction Status LED for PlumeOS
Event
Solid Power On
Pulsing Attempting to Connect
During device naming (this device) and waiting for optimization to finish
Off During device naming (other devices)
Off Internet working
Internet down (with power) or Internet still connected but lost cloud con-
nection.
Off Cloud planned outage
Pulsing Claimed device (by another account)
TFTP/recovery blink
State Description
On Wi-Fi radio is UP.
Flashing Wi-Fi radio is transferring data.
Off Wi-Fi connection is DOWN.
State Description
Flashing Pairing mode - waiting for WPS client
State Description
On Telephone is off-hook. A call is in progress.
Flashing Telephone is off-hook.
Off Telephone is on-hook.
Figure 2.
Figure 2. Status LEDs
834-v6 Gigabit Router QSG
6SDG834V6-13A