Advertisement
2. For a Voice connection, insert an RJ-11 cable into one of the telephone ports labeled (Tel 1 or Tel 2) until there is an audible "click".
Connecting the Power Supply
1. Connect the end of the power adapter to the Power port on the rear panel of the gateway
2. Plug other end of the power adapter into the wall outlet.
3. Confirm that the power is connected properly. The Power LED should be lit on the front of the gateway.
NOTE
g
Alternately, the device may be powered by a supported third-party UPS which may be connected via 7-pin molex connector, labeled UPS.
Resetting the Gateway
A reset button is available if the 825-v6 needs to be rebooted. To reboot the 825-v6, press the Reset button on the rear panel of the gateway for 5
seconds or less. To reset the device to custom defaults, press the Reset button for 5 seconds or more.
Understanding the Status LEDs
The LEDs on the back panel of the 825-v6 gateway enable you to monitor the device status. This section describes the three types of LEDs available on
the 825-v6 gateway. See
Figure 3
2.4 GHz / 5 GHz Status LEDs
The 2.4 GHz and 5 GHz status LEDs indicate the state of the wireless connections on the gateway.
LED
Color
State
On
Green
2.4 GHz
Flashing
5 GHz
None
Off
WPS Status LED
The WPS status LED indicates the status of WPS (Wi-Fi protected setup).
LED
Color
State
On
Green
WPS
Flashing
None
Off
Tel 1/2 Status LED
The Tel 1/2 status LED indicate the state of the phone line ports.
LED
Color
State
On
Green
Tel 1/2
Flashing
4
for details.
Description
Wi-Fi radio is UP.
Wi-Fi radio is transferring data.
Wi-Fi connection is DOWN.
Description
WPS is enabled.
WPS is passing traffic.
WPS is not active.
Description
Telephone is off-hook; a call is in progress.
Telephone is off-hook.
Figure 3. Status LEDs
617600139F1-13A
Advertisement
