Table of Contents
Advertisement
Understanding the Status LEDs
Resetting the Device
A reset button is available on the back of the SDG-8612 and SDG-8614 as shown in
the device to factory defaults. To reboot the SDG-8612 or SDG-8614, press the Reset button on the back panel of the device for less than 5
seconds. To reset the device to factory defaults, press the Reset button for 5 seconds or longer.
Understanding the Status LEDs
There are several different LEDs on the SDG-8612 and SDG-8614 SDGs that provide information on the device, interfaces, and connectivity
status. See
Figure 1
on page 1 to locate the different LEDs on the unit.
Multifunction Status LED
The multifunction status LED on the front of the SDG indicates the device and connectivity status.
state when running SmartOS.
Color
Blue
Red
Green
Light Blue
White
Amber
Purple
White
Red
Amber
White
SFP Status LED (SDG-8614 only)
When the SFP fiber connection is active, the SFP status LED will indicate the status of Fiber connectivity.
LED
Color
Green
SFP
Red
Ethernet Status LEDs
The Ethernet status LEDs indicate the status of the Ethernet interfaces.
LED
Ethernet
Quick Setup for the SDG-8612 and SDG-8614
For devices with SmartOS installed, scan the QR code labeled WiFi QuickStart located on the back of the unit. You will be presented with a
series of self-guided steps to choose your account password, select gateway or access point mode, and configure the Wi-Fi SSID and
passphrase. The specified account password will be used when logging into the GUI in the SDG.
4
Table 2: Multifunction Status LED for SmartOS
LEDState
Event
Solid
Cold boot
Pulsing
Reboot and system upgrade (persists over uboot)
Pulsing
Linux booting up
Pulsing
Quick Start
Solid
Controller WAN up, Internet
Pulsing
Controller WAN down, no Internet
Pulsing
Satellite set up
Solid
Satellite up
Pulsing
Satellite up, fair signal
Pulsing
Satellite up, poor signal
Pulsing
Reverting
Table 3: SFP Status LED
State
Description
On
Loss of signal (LOS) is cleared.
On
LOS is set.
Table 4: Ethernet Status LED
Port
Color
Left Green
2.5Gbps
Right Green
Right Amber
Green
1Gbps
Amber
Figure 1
on page 1 and can be used to reboot or restore
Table 2
Description
Speed is 2.5 Gbps
Speed is 1Gbps
Speed is 100Mbps
Speed is 1Gbps
Speed is 100Mbps
8612 and 8614 Router QSG
defines the multifunction status LED
6SDG861214-13A
Advertisement
Table of Contents
