Intrusion Switch; Removing The Intrusion Switch - Dell Precision 7865 Tower Service Manual

Steps
1. Press the tabs on the speaker and slide the speaker in the slot on the chassis until it snaps into place.
2. Route the speaker cable through the routing guide on the chassis.
3. Route the speaker cable through the slot on the chassis.
4. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the air shroud.
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in

Intrusion switch

Removing the intrusion switch

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the air shroud.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 77