Chapter 2: Removing And Installing Components; Recommended Tools; Screw List - Dell Precision 7865 Tower Service Manual
Hide thumbs
Also See for Precision 7865 Tower:
- Setup and specifications (23 pages) ,
- Manual (13 pages)
Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx T20 screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Front I/O bracket
Front fan
Rear fan
Solid-state drive1
solid-state drive2
Heat sink
Hard-drive fan assembly
Screw type
Captive
M3x5
#6-32
M2x3.5
M2x3.5
Captive: Torx T20
M3x5
Quantity
1
1
2
1
1
4
2
Removing and installing components
Screw image
2
11
Advertisement
Table of Contents
