Table of Contents
Advertisement
3.
Disconnect the battery cable from the system board (see
4.
Remove the system board (see
5.
Remove the antenna barrel (see
Remove the display assembly:
To remove the display assembly:
■
a.
Remove the three Phillips M2.0 × 4.0 screws (1) from each hinge.
b.
Open the computer (2), and then separate the computer from the display (3).
Reverse this procedure to install the display assembly.
Display hinges
To remove the display hinges, use these procedures and illustrations. The display back cover with leather
(spare part number N22920-001) remains after removing all other spare parts from the display.
Before removing the display hinges, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
4.
Remove the display panel (see
5.
Remove the system board (see
6.
Remove the antenna barrel (see
7.
Remove the display assembly from the computer (see
System board and audio jack on page
Antenna barrel on page
Preparation for disassembly on page
Bottom cover on page
33).
Display panel and subcomponents on page
System board and audio jack on page
Antenna barrel on page
Display assembly on page
Battery on page
42).
50).
53).
33).
Battery on page
42).
56).
50).
53).
72).
Display hinges
73
Advertisement
Table of Contents
