Table of Contents
Advertisement
1.
Remove the tape from the connectors on the module (1).
2.
Loosen the two captive screws from the right fan (2).
3.
Carefully disconnect the antenna cables from the connectors on the module (3).
4.
Peel the gray conductive tape off the module (4). You can leave the tape connected to the connector.
5.
Remove the Phillips M1.6 × 1.6 screw (5), and then pull the module out from under the plastic that
extends over it from the thermal module (6).
NOTE:
4G WWAN module.
6.
If the WWAN antenna is not connected to the terminal on the WWAN module, install a protective sleeve
on the antenna connector, as shown in the following illustration.
40
Chapter 5 Removal and replacement procedures for authorized service provider parts
4G WWAN modules come with a reusable bracket. Be sure to use this bracket when installing a
Advertisement
Table of Contents
