Wireless Antennas And Cables - HP Dragonfly Folio Maintenance And Service Manual

Wireless antennas and cables

To remove the wireless antennas and cables, use this procedure and illustration.
Table 5-15 Wireless antennas and cables description and part number
Description
Wireless antennas and cables (aux2)
Wireless antennas and cables (aux3)
Before removing the wireless antennas and cables, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the wireless module (see
5. Remove the heat sink (see
6. Remove the system board (see
Remove the wireless antennas and cables:
1. Peel up the orange cable that the left antenna cable runs underneath (1).
2. Peel the left and right antennas off the chassis (2).
3. Remove the left antenna cable from the clips along the side and top of the computer (3).
4. Remove the tape next to the SIM board that secures the right cable to the chassis (4).
5. Remove the antennas and cables from the computer (5).
To install the wireless antennas and cables, reverse this procedure.
Preparation for disassembly on page
Bottom cover on page
Wireless charging module on page
Heat sink on page 47).
System board and audio jack on page
33).
Battery on page 42).
41).
50).
Wireless antennas and cables
Spare part number
N22921-001
N22922-001
33).
55