Step Three - Run The User Interface Software - Fluke OptiView III Series Getting Started Manual

Workgroup analyzer
Hide thumbs Also See for OptiView III Series:
Table of Contents

Advertisement

Step Three – Run the User Interface Software
When you launch the user interface software (an icon is placed on your desktop), the analyzer will
automatically be listed in the OptiView Browser list as long as it is in the local network (broadcast domain).
Figure 7 shows a WAN connection where you will need to configure the remote PC IP address in the Setup |
Remote screen in order to see it in the OptiView Browser.
Note the Local Host Software Revision number. This number should match the Firmware Revision numbers
displayed for each analyzer. If the firmware revision displayed is a lower number than the local host software
revision number, select that analyzer and click on the update firmware button (right-most on the button
bar). The software will begin its update process of the firmware on the selected analyzer.
The Connection type has to show "management port" for the update firmware
button to be enabled. You cannot update the analyzer's firmware through a network
measurement interface, only through the Management Port.
Older OptiView Workgroup Analyzers running firmware less than version 5.2 can only
be updated to firmware version 4.09. A yellow triangle will appear next to analyzers
less than 4.09 but greater than 3.51 indicating they can be updated to 4.09. OptiView
Workgroup Analyzers running 3.51 or less firmware can not be updated.
You cannot update OptiView
procedure for OptiView
Once the user interface software is finished flashing new firmware into your analyzer, the Update
Complete dialog box will be presented. Select OK and continue updating all of the OptiView
Analyzers in this manner until all of the firmware revisions match the host software revision number.
Figure 7. Remote Management Port Connection
Integrated Network analyzers using this method. See the software update
TM
TM
Integrated Network analyzers in the analyzer Help.
Updating the OptiView Workgroup Analyzer Firmware
WAN
Note
Workgroup Analyzer
anj06f.eps
TM
Workgroup
19

Advertisement

Table of Contents
loading

Table of Contents