Hard Disk Connector: Ide1; Chassis Intrusion Switch Connector: Jcase1 - MSI 915GLM4-F User Manual

Hard Disk Connector: IDE1

The mainboard has 1 IDE port and support the following function in the list.
IDE1
IDE1 (Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can connect a
Master and a Slave drive. You must configure second hard drive to Slave mode
by setting the jumper accordingly.
MSI Reminds You...
If you install two hard disks on cable, you must configure the
second drive to Slave mode by setting its jumper. Refer to the
hard disk documentation supplied by hard disk vendors for jumper
setting instructions.

Chassis Intrusion Switch Connector: JCASE1

This connector is connected to a 2-pin chassis switch. If the chassis is
opened, the switch will be short. The system will record this status and show
a warning message on the screen. To clear the warning, you must enter the
BIOS utility and clear the record.
IDE1 Definition
IDE VDMA Controller
1 66/100 Intel ICH6
2
GND
CINTRU
1
JCASE1
Hardware Setup
RAID ATAPI
N/A Yes
2-15