Onboard Parallel Port - MSI 694T Pro User Manual

of block read/writes per sector the drive can support. The settings are:
Enabled, Disabled.
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDD)
installed on the system board and you wish to use it. If you install add-on
FDC or the system has no floppy drive, select Disabled in this field.
The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and
second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
UART 2 Mode
This item allows you to select which mode for the Onboard Serial Port
2. The settings are: Standard, HPSIR, ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex function.
TX, RX inverting enable
This item allows you to enable the TX, RX inverting which depends
on different H/W requirement. This field is not recommended to change its
default setting for avoiding any error in your system.

Onboard Parallel Port

There is a built-in parallel port on the on-board Super I/O chipset that
provides Standard, ECP, and EPP features. It has the following options:
Disable
3BCH/IRQ7 Line Printer port 0
278H/IRQ5
378H/IRQ7
Line Printer port 2
Line Printer port 1
4-17
®
AWARD BIOS Setup