MSI 661FM2-V ILSR User Manual page 51

MS-7060 Micro ATX Mainboard
Onboard SuperIO Device
Press <Enter> and the following sub-menu appears:
Onboard FDC Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select [Disabled] in this field. Setting options: [Enabled], [Disabled].
Onboard Serial Port 1/Serial Port 2
This item specifies the base I/O port address and IRQ for the onboard Serial Port
1 (LPT1B)/Serial Port 2 (JCOM1). Selecting [Auto] allows BIOS to automatically
determine the correct base I/O port address. Setting options: [Disabled], [3F8/
IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3], [Auto].
Onboard Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port. Setting
options: [378/IRQ7], [278/IRQ5], [3BC/IRQ7], [Disabled].
Parallel Port Mode
This item selects the operating mode for the parallel port: [Normal], [SPP], [EPP],
[ECP], or [ECP+EPP].
[SPP]
[EPP]
[ECP]
[ECP + EPP]
[Normal]
EPP Mode Select
This item selects the EPP mode. Setting options: [EPP1.9], [EPP1.7].
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard parallel port
with the ECP feature. After selecting it, the following message will appear: "ECP
Mode Use DMA." At this time, the user can choose between DMA channel [3] or
[1].
VIA 1394 Controller
This item allows you to enable/disable the onboard IEEE1394 controller. Setting options:
[Enabled], [Disabled].
Init Display First
This item specifies which VGA card is your primary graphics adapter. Setting options:
[PCI Slot], [AGP].
3-16
Standard Parallel Port
Enhanced Parallel Port
Extended Capability Port
Extended Capability Port + Enhanced Parallel Port
Standard Parallel Port + Bi-Directional Mode.