Icons; Create Icon On Plotter - Lowrance M52 S/GPS Installation And Operation Instructions Manual

3. Press → to
4. Press ↓ to
begins showing navigation information along the trail, in reverse.
NOTE:
If you are already located at or near the end of your trail, the arri-
val alarm will go off as soon as you hit Enter. Just press
clear the alarm and proceed.
5. Now, begin moving and follow your M52.
6. When you reach your destination, be sure to cancel your navigation:
press |
MENU MENU
sure; press ←|

Icons

Icons are graphic symbols used to mark some location, personal point of
interest or event. They can be placed on the plotter screen, saved and
recalled later for navigation purposes. These are sometimes referred to
as event marker icons. The M52 has 42 different symbols you can pick
from when creating an icon.
Icons are similar to waypoints, but they do not store as much informa-
tion (like names) as waypoints do. You can't use a menu to navigate to
icons as you can with waypoints. (But, you can use the plotter cursor
and navigate to any icon on the plotter.)
You can create an icon at the cursor position on the plotter, or at your
current position while you are navigating.

Create Icon on Plotter

1. Use the arrow keys to move the cursor to the place where you want
to make an icon.
2. Press and the screen shows a "Select Icon Symbol" menu.
ENT
3. Press ← or ↑ or → or ↓ to select your icon symbol, then press
The icon appears on the plotter.
|↓ to
D T
ELETE RAIL
|→ to
N
AVIGATE
|↓ to
C
ANCEL
.
ENT
|
N ENT
AVIGATE
| |← to
R ENT
EVERSE
|
N
AVIGATION
99
.
|
N
AVIGATE
. The M52 asks if you're
ENT
. The unit
ENT
to
EXIT
.
ENT