Map Fix - Lowrance M52 S/GPS Installation And Operation Instructions Manual

Map Fix

Map Fix is used with charts or maps. This system asks for a reference
position in latitude/longitude, which you take from a marked location
on the map. It then shows the present position as distance on the map
from that reference point.
For example, if it shows a distance of UP 4.00" and LEFT 0.50", you
then measure up four inches and to the left a half-inch from the refer-
ence point on the map to find your location.
To configure a map fix:
To use this format, you need to follow these steps in order. First, take
your map of the area and determine a reference latitude/longitude.
(Please note that in order for this system to work, the lati-
tude/longitude lines must be parallel with the edge of the map. USGS
maps are parallel, others may not be. Also, this works better with
smaller scale maps.) The reference position can be anywhere on the
map, but the closer it is to your location, the smaller the numbers will
be that you'll have to deal with.
Once you've decided on a reference position, you can save it as a waypoint.
See the waypoint section for information on saving a waypoint. Save the
reference position as a waypoint. Exit from the waypoint screens.
1. Press
MENU
2. Press ↓ to
C
3. Press ↓ to
S
The following screen appears, and
and enter the map's scale. This is generally at the bottom of the paper
map. It's shown as a ratio, for example 1:24000. Press
returns to the Configure Map Fix screen.
Configure a map fix so the M52 can find your position on a printed
| |↓ to
MENU GPS S
S
OORDINATE YSTEM
|
M F ENT
ETUP AP IX
chart or topographical map.
| .
ENT
ETUP
| .
ENT
.
M S
AP CALE
111
is highlighted. Press
and the unit
EXIT
ENT