Edit A Trail Name; Navigate A Trail - Lowrance M52 S/GPS Installation And Operation Instructions Manual

Edit a Trail Name

To edit a trail name: press
name|
ENT|ENT
to the next character and repeat until the name is correct. Press
then |
EXIT EXIT
Tip:
You can quickly call up the Edit Trail menu by selecting a trail on
the plotter with the cursor. Simply move the cursor over a trail and
a pop-up box appears. Press
At left, trail selected with plotter cursor. The info box at the bottom of
the screen shows distance and bearing from current position to the
selected point on the trail. At right, the Edit Trail menu.

Navigate a Trail

There are three methods for following a trail: visual trailing, navigating
a trail (forward) and backtracking a trail (backward). Try each method
to see which you prefer.
Visual trailing is the simplest method. It uses only the Plotter Page and
requires no menu commands at all. The technique works the same if
you are running a trail forward (from start to end) or backward (from
end to start.) However, visual trailing provides no navigation informa-
tion during the trip, such as the time to your destination.
The other two methods provide a full range of navigation data and work
with both the Plotter Page and Navigation Page. The only difference be-
MENU
. Press ↑ or ↓ to change the first character, then press →
| | to return to the previous page display.
EXIT EXIT
| |↓ to
MENU
and the Edit Trail menu opens.
WPT
95
|
M T ENT
Y RAILS
|↓ to trail
ENT