Connecting A Lms-350/A To The Globalmap 2000 - Lowrance GlobalMap 2000 Installation And Operation Instructions Manual

Connecting a LMS-350/350A to the GlobalMap 2000
To connect a Lowrance LMS-350 or LMS-350A with a GPS module to the
GlobalMap 2000, first follow the wiring diagram at the bottom of this page.
After all wiring is completed, plug the two units in and turn them on. On the
LMS-350, then press the GPS key, then
the MENU key. Now press the key next to
the "Change GPS Settings" label. Press
the key next to the "Select NMEA" label.
The screen shown at right appears. Now
press the key next to the "Select NMEA
0183" label. Finally, press the key next to
the "Exit" label. The LMS-350 will send
position information to the GlobalMap
2000 as soon as the GPS module locks
on to the satellites. The GlobalMap 2000
doesn't need any setup.
GLOBALMAP 2000
NMEA CABLE
BLACK WIRE
GLOBALMAP 2000
POWER CABLE
RED WIRE WHITE WIRE
12 VOLT
BATTERY
GLOBALMAP 2000 RECEIVING
NMEA 0183 VERSION 1.5 DATA
FROM THE LMS-350
13
LMS-350 MENU
LMS-350
POWER CABLE
BLACK WIRE