Power Connections; Data Input And Output Connections - Lowrance GlobalMap 2000 Installation And Operation Instructions Manual

RUBBER PAD
BOLT
CAM CLAMP
(TURNED DOWN)
clamp on the right side of the unit is pointing up before you start tightening
the bolts.

POWER CONNECTIONS

This product works from a twelve-volt battery system. For the best results,
attach the power cable directly to the battery. You can attach the power
cable to an accessory or power buss, however you may have problems
with electrical interference. Therefore, it's safer to go ahead and attach the
power cable directly to the battery. If the cable is too short, splice 18 gauge
wire onto it. A silver label identifies the power supply portion of the cable.
It has four wires; red, black, green, and white. Red is the positive lead,
black is negative or ground. Make certain to attach the in-line fuse holder
to the red lead as close to the power source as possible. For example, if
you have to extend the power cable to the battery or power buss, attach
one end of the fuse holder directly to the battery or power buss. This will
protect both the unit and the power cable in the event of a short. It requires
a 3-amp fuse.
Do not use this product without a 3-amp fuse wired into the power cable!
Failure to use a 3-amp fuse will void your warranty.

DATA INPUT AND OUTPUT CONNECTIONS

This mapping unit requires navigation data to show position information.
This can come from either a Lowrance GPS module, Lowrance GPS
receiver, or another manufacturer's navigation receiver that can send the
data in NMEA 0183 version 1.5 or 2.0 format. If you use the Lowrance GPS
module, the NMEA input is not used. If you use any other navigation
receiver for position information, then the NMEA input will have to be used.
It can also accept sonar information from any SAM sonar access module,
which also doesn't require the NMEA input.
LOWRANCE
IMPORTANT!
4
RUBBER PAD
BOLT
CAM CLAMP
(TURNED UP)