Camera Installation - Lorex SHS-2S7LD Series Instruction Manual

Camera Installation

Before you install the camera, carefully plan where and how you will position the camera, and
where you will route the cable that connects the camera to the SHS-2S7LD.
Installation Warnings:
• Select a location for the camera that provides a clear view of the area you want to monitor,
which is free from dust, and is not in line-of-sight to a strong light source or direct sunlight.
• Do not install the camera in a location where it will be
• Plan the cables' route so that it is not close to power or telephone lines, transformers,
microwave ovens or other electrical equipment that could interfere with the system.
• Select a location for the camera that has an ambient temperature between 14
° °
(-10 C~50 C)
• If you plan to install the camera in a location that has conditions not recommended in this
manual, consult with a professional installer and consider use of a separate camera cover
or housing
• Before starting permanent installation, have another person hold the camera for you while
you verify its performance by observing the image on the monitor.
Camera Stand Installation:
1. Attach the pedestal to the ceiling,
wall or other surface by the base
using the provided screws.
2. The mounting bracket must be
attached to a structural device
such as a wall stud or ceiling
rafter using the supplied screws.
3. Attach the camera
pedestal. Adjust the angle of the
camera, and tighten
thumbscrew to set the position
to the
the
Camera Installation
° °
F~122 F
13